ATIKA ALA 2800, Original Instructions Manual

Page: 13 / 148

14
ƒ
When running the connection line observe that it does not
interfere, is not squeezed, bended and the plug connection
does not get wet.
ƒ Wind off completely the cable when using a cable drum.
ƒ Do not use the cable for purposes for which it is not meant.
Protect the cable against heat, oil and sharp edges . Do
not use the cable to pull the plug from the socket.
ƒ
Regularly check the extension cables and replace them if
they are damaged.
ƒ Do not use any defective connection cables .
ƒ When working outdoors, only use extension cables especial-
ly
approved and appropriately labelled for outdoor use.
ƒ
Do not set up any provisional electrical connections .
ƒ
Never bypass protective devices or deactivate them.
ƒ
Only hook up the machine by means of a fault-current
circuit breaker (30 mA).
The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician
or one of our customer service points. Local regulations –
especially regarding protective measures – must be ob-
served.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service
points.
Use only original spare. Accidents can arise for the user
through the use of other spare parts. The manufacturer is
not liable for any damage or injury resulting from such ac-
tion.
C
C
o
o
m
m
m
m
i
i
s
s
s
s
i
i
o
o
n
n
i
i
n
n
g
g
ƒ
Check that the machine is completely and correctly assem-
bled.
ƒ
To avoid toppling, place the shredder on a firm horizontal
surface.
ƒ
Do not use this machine on a paved area covered with
gravel on which thrown out material can cause injury.
ƒ The machine should only be operated in the open. Always
maintain a safe distance (at least 2 m) from walls or other
fixed objects.
ƒ
Before each use , check
−
Connection cables for defects (cracks, cuts, etc.).
Do not use any defective cables.
−
There are no damage at the machine (see safety instruc-
tions).
−
that all screws, nuts and bolts as well as other fasteners
are securely tightened
−
that covers, deflectors and protective shields are on their
correct position and in good working condition.
L
Mains connection
ƒ
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the machine to
the relevant and properly earthed plug.
ƒ Only use extension cables with sufficient core cross-section.
Mains fuse
16 A time-lag
On / Off switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Switch on
Press the green button .
Switch off
Press the red button .
Restart protection in case of power
failure
In case of a power failure, the device switches off automatically
(zero-voltage initiator). To restart, press the green button again.
Motor protection
The motor is equipped with a safety switch and switches off
automatically when overloaded. After a cooling-down break
(approx. 5 min), the motor may be restarted. Press the
1. reset button (motor protection)
2. green button to restart.
Direction of rotation selector switch
Only actuate the direction of rotation selector switch
while the shredder is switched off.
Position
Motor does not start.
Position
The material is drawn in by the cutting roller and shredded.
Position
The blades operate in the opposite direction and jammed
material is released.
Reset button
(motor protec-
tion)
ON
OFF
Reverse Infeed
Direction of
rotation selector
switch
OFF