INSTALLATION INSTRUCTIONS
GENERAL INFORMATION AND FEATURES
210-0197_Libretto_TX_ATI_2020-02_ATI-eng
9
ed. 2020-02
11 LOCAL REGULATIONS, AND INSTALLATION OF SAFETY
LOCAL REGULATIONS
In the installation the local regulations must be observed regarding:
Fire fighters
Gas Company
power Company
Office hygiene and health
SAFETY RULES
Do not perform any cleaning or maintenance work without turning off the water heater and interrupting power
supply.
E 'absolutely forbidden to operate the water heater with protection of electrical parts or disassembled safety
equipment excluded. E 'absolutely it is forbidden to remove or tamper with safety devices.
In case of failure and / or malfunction switch off the appliance, close the gas valve and not groped to repair it but
contact an authorized service center.
In case of fire should be used in powder extinguishants: not direct jets of water directly against the heaters as they
may cause short circuits.
Apply tools and / or equipment manuals and / or electrical proper use, they are in good condition and used
properly.
Make sure that ladders and / or any rolling ladders are positioned securely, that are appropriate and that the steps
are intact and not slippery, that they are not moved when someone climbs them and ensure someone supervises.
INSTALLATION INSTRUCTIONS
Make sure, for installation and maintenance work at height (generally with higher altitude to two meters), which
are used in scaffolding standards and the space below is free during the eventual fall of tools and objects.
Make sure that, in case of installation and maintenance, the workplace has adequate hygienic conditions with
regard to lighting, aeration and solidity.
Wear during installation and maintenance, clothing and adequate personal protective equipment.
Do not take any action without a prior assessment of the absence of gas leaks using special detector.
The installer must be enabled in the installation of heating equipment according to the law n. 46 of 05/05/1990 and
after work must issue the CONFORMITY 'DECLARATION to the customer.
The appliance must be connected to a hot water distribution network compatible with its performance and its
power. Make sure the installation site and any systems to which it must connect the device comply with the
current regulations.
Before each installation, maintenance or repair, remove the power supply. Protecting tubes and external
connection cables in such a way as to prevent them from being damaged.
The device is to be installed on the floor surface, leaving a suitable distance from the side walls to allow the gas
and water connections, as well as any maintenance interventions. Furthermore, the appliance must be installed on
a solid floor, not subject to vibration, not uneven or non-planar.
The operations inside the unit must be performed with caution so as to avoid abrupt contact with sharp parts.
Do not take any action without a prior assessment of the absence of an open flame or ignition sources.
If you detect a smell of burning, see the smoke out exit from the apparatus, or is felt strong smell of gas, remove
the power supply, close the gas valve, open the windows and notify the authorized service centers nearest
IN ANY SITUATION AND 'WELL ALWAYS REMEMBER THAT COMMON SENSE
IS THE BEST SECURITY AGAINST ANY AND / OR INJURY.
