INSTALLATION INSTRUCTIONS
210-0197_Libretto_TX_ATI_2020-02_ATI-eng
14
ed. 2020-02
Model 160
1)
Turn off the machine, close the gas shut-off valve and remove the power supply
2)
Remove the burner door (A) and the insulating material (B)
POWER CONVERSION TO PROPANE GAS G31
TRANSFORMATION POWER GAS NATURAL GAS
G20
3)
Unscrew the 4 screws (C), place the mask (D) in
front of the burner and tighten the screws (C)
3)
Unscrew the 4 screws (C), removing the mask (D) in
front of the burner and tighten the screws (C)
4)
Replace injector (E). Be careful not to lose the washers seal
5)
Put the appliance into operation and check with appropriate spray the gas circuit
6)
Replace the burner door (A) and the insulating material (B) in their original positions and tighten the fastening
screws.
7)
Adjust the pressure to the burner, according to the specified value, through the REG screw on the gas valve. To
check the value you can use the outlet pressure of P.OUT
8)
Stick the label contained in the kit to indicate the new type of gas supply
Models
220
300
400
600
800
1)
Turn off the machine, close the gas shut-off valve and remove the power supply
2)
Remove the burner door (A)
3)
Unscrew the gas pipe (B)
4)
Loosen the screws (D) present in the left and right side of the burner assembly
5)
Replace the two closure plates slots (C) with those present in the gas conversion kit. The opening
must remain in the lower part
POWER CONVERSION TO PROPANE GAS G31
TRANSFORMATION POWER GAS NATURAL GAS
G20
6)
Unscrew the 4 screws (F), place the mask
(G) in front of the burner and tighten the
screws (F)
6)
Unscrew the 4 screws (F), removing the
mask (G) in front of the burner and tighten
the screws (F)
7)
Replace injectors (H). Be careful not to lose the washers seal
8)
Connect the gas pipe (B)
9)
Put the appliance into operation and check with appropriate spray the gas circuit
