ATI
Q46UV UV254/Turbidity Monitor
Part 2
– Analyzer Mounting
11
O&M Manual
Rev-D (11/19)
2.3
Panel Mount, AC Powered Monitor
Panel mounting of an AC powered monitor uses the panel mounting flange molded into the rear
section of the enclosure.
Figure 5 - Panel Mount Diagram
Figure 5 provides dimensions for the panel cutout required for mounting. The panel mounting
bracket kit must be ordered separately (part number 05-0068). This kit contains a metal retainer
bracket that attaches to the rear of the enclosure, 4 screws for attachment of this bracket, and a
sealing gasket to insure that the monitor flange provides a water tight seal when mounted to a
panel.
The sealing gasket must first be attached to the enclosure. The gasket contains an adhesive on
one side so that it remains in place. Remove the protective paper from the adhesive side of the
gasket and slide the gasket over the back of the enclosure so that the adhesive side lines up with
the back of the enclosure flange. Once in place, you can proceed to mount the monitor in the
panel.
