ATI Technologies FireGL V3400, User Manual

Page: 37 / 70

Setting the ATI HDTV Component Video Adapter DIP Switches 31
Setting the ATI HDTV Component Video
Adapter DIP Switches
Configure the DIP switches to set the appropriate display mode and aspect
ratio. This sets the modes which appear when you select
Show all Modes
in the ATI Control Panel as described in See “Using Your ATI HDTV
Component Video Adapter”.
Display Modes
The six DIP switches on the ATI HDTV Component Video Adapter enable
four, standard HDTV video modes: 480i, 480p, 720p,and 1080i. The
default setting is 480i or 480p, depending upon your component input
device. In the example below, 480i, 480p, and 1080i are supported.
Use a small, flat-head screwdriver to set the switches - the up position is
ON, and the down position if OFF. Set the switches ON for all modes that
your HDTV or component input device supports.
Aspect Ratio
If your display supports 16:9 aspect ratio, set DIP switch 6 (16:9) ON. This
switch toggles between 4:3 and 16:9 - OFF is 4:3.
L
• DIP switch 3 is always OFF (540p is not supported)
• Set all DIP switches ON that correspond to the modes that your
component input device supports; for further details, consult the
manual for your component video input device.