Manual, F/T Sensor, Data Acquisition (DAQ) Systems
Document #9620-05-DAQ.indd-20
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •
• Email:
45
4.5.6.1 Installing 12 Pin Jumpers on the Backplane to Make Unused
Transducer Signals Available to the User
Tools required: #2 Phillips head screw driver
Parts required: 12 pin jumpers supplied with the IFPSMC Box (ATI part
number1590-2225000-12) (Amphenol FCI part number 69145-212LF)
NOTICE:
The following steps must be performed at an anti-static
workstation.
NOTICE:
Make sure the transducers are re-connected to the same
connector on the front panel when re-assembling the IFPSMC box. Also
ensure the transducers and the connector on the front panel are clearly
marked with the serial number label.
1.
Disconnect all cables, transducers and the power supply from the IFPSMC box.
2.
Remove the (4) M4 pan head screws from the front panel using a Phillips head
screw driver.
3. Carefully rotate the front panel open to the right side of the box, as shown in
Figure 4.17—IFPSMC Box Disassembly
(4) M4 Pan Head Screw
Front End Plate with
Transducer Connectors
IFPSMC Box
IDAQ PS Board Assembly
Plastic Loops
FT Serial Number Label
4. Disconnect all the DAQ boards from the backplane by firmly holding the top of
the IFPSMC box and simultaneously pulling the two plastic loops attached to each
board. Pull each board out about 1/2” to disconnect it from the backplane.
5.
Remove the (4) M4 pan head screws from the back panel using a phillips head
screw driver.
