ATH-Heinl W102, Operating Instructions Manual, Page: 74 / 358

® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Manufacturer ATH-Heinl GmbH & CO.KG
- 28 -
4.4 Maintenance or Service Plan
Interval
Imm
ed
ia
te
ly
W
ee
kl
y
M
on
th
ly
Ev
ery
3
mo
nt
hs
Ev
ery
6
mo
nt
hs
Check of ALL safety-relevant parts X
Cleaning X
Check or restore surface protection X
Check for leaks in the hydraulic system X
Check or restore surface protection or corrosion protection X
Check or restore damage to the paint and components X
Check or restore rust damage X
Check or treat cavities and non-painted areas X
Check for leaks in the pneumatic system X
Control the tightness of screws X
Check, lubricate & adjust bearing slack X
Check wear parts X
Check fluids (level, wear, contamination, quality) X
Check and lubricate sliding surfaces X
Remove any dirt inside X
Clean and check electrical components X
Check motor and transmission for function and wear X
Check welds and construction X
Visual inspection (according to inspection plan) X
4.5 Troubleshooting / Error Display and Solutions
The balancing computer may display the following error messages:
Error Code Reason
Err -1- See troubleshooting
Err -2-
1. There is no wheel on the shaft, or wheel is too light
2. Balancing shaft is not tightened
3. Wheel was not sufficiently secured
4. Ribbed belt not or too weakly tensioned
Err -3- Wheel imbalance is too great
Err -4-
Defective pressure sensor
Rotates in wrong direction
Err -5- Wheel cover is not closed
Err -7- Saved data has been deleted
Err -8-
100g weight missing
Defective pressure sensor
Defective power board or motherboard