® Copyright by ATH-Heinl GmbH & Co. KG, 2019, All rights reserved / Misprint and technical changes reserved / Issue: 2019/02
- 13 -
Fixing
It is recommended to fix the machine on the intended points with anchor screws M16 or corresponding
anchors on the floor.
Bore holes, pay attention
in doing so to the
necessary boring depth
A and the boring
diameter of the anchor
manufacturer.
Clean the inner of the
holes
Put the anchor bolts into
the holes until you reach
the bottom of the hole.
Tighten the nut with the
necessary torque
specified by the
manufacturer. Clamping
thickness B depends on
flooring.
Electrical connection
Here, the general and local regulations must be observed. Therefore, this step must be
performed only by an expert.
Pay attention to the correct current supply. (see technical data).
The connection should be made with a 5-phase 16 A CEE plug (not in scope of delivery).
The machine must be grounded.
The voltage deviation should be max. 0,9
–
1,1 times of the nominal voltage range and the frequency
deviation should be max. 0,99
–
1,01 times of the frequency range.
To guarantee this, necessary safety measures must be made.
For finishing the works the rotating direction of the motor (at 400V) must be checked.
Press the pedal which is responsible for the rotating direction of the turntable downwards.
In doing so the turntable should rotate clockwise.
If the turntable rotates in the wrong direction, change two phases in the connecting plug.
Summary of Contents for M72Z
Page 1: ...USER S MANUAL ATH M72Z...
