® Copyright ATH-Heinl GmbH & Co. KG, 2012, All rights reserved. / Misprints and technical changes reserved / Issue: 04/2014
27
Lubrication plan
Interval:
Components:
Oil or type of grease:
Monthly
Guide pulleys
Multi-purpose grease
Sliding guides
Multi-purpose grease
Quarterly
Synchronization ropes
Adhesive grease
Drive-on ramps (Roll-away protection)
Greasing
Centers of pulleys and safety notches
Multi-purpose grease
Maintenance- and service instructions
Control of oil level
1. Lower the lift completely
2. Remove tank cap
3. Control at tank cap the oil level
Oil change
1. Lower the lift completely
2. Remove the oil filler screw
3. Remove carefully the oil drain screw and drain the oil into a suitable container.
Clean the tank and oil filter to avoid an early contamination of the hydraulic oil.
4. After the complete draining of the oil lock the tank with the oil drain screw
5. Fill the new oil into the tank
6. Raise and lower the lift and check, if the maximum lifting height is still correct. If necessary refill carefully.
The used oil must be disposed under consideration of all legal regulations.
Bleeding of hydraulic system
1. Lower the lift completely.
2.
Push the button „
DOWN
“ and push at the same time the piston until minimum into the cylinder.
