Images and instructions are for reference only and subject to change. © 2022 AtGames.
HOW TO INSTALL TRACKBALL ONTO ALU
2
Remove the screws attaching the control panel to
the cabinet. (If you have the Pinball Kit installed,
please remove) Partially slide out the control panel
and carefully unplug the rear connecting cables.
Once cables are unplugged, fully remove the
control panel.
Step 1
Flip the control panel upside down and remove all
8 screws on the bottom of the control panel.
Step 2
Carefully hold the trackball ball and rim from
underneath the control panel to avoid damaging
it as you remove the 7 screws indicated.
Step 5
Prepare a new trackball.
Step 6
Carefully remove the control panel's bottom
casing and carefully disconnect the Pinball cables
from the sides.
Important note: The control panel's bottom casing may be
difficult to remove due to a tight fit around the housing with
the ports. May need to carefully rock side to side while lifting
to remove. Again, please be careful of the Pinball cables.
Step 3
Remove the cable circled in yellow.
Step 4
