Atest Gaz ProGas 4, User Manual

Page: 14 / 48

www.atestgaz.pl
The Bluetooth interface behavior depends on the operation mode selected for the Bluetooth port upon
configuration and presence of a permanent magnet. See details in Table 7 below.
Operation of the Bluetooth interface
Permanent magnet
in place
The detector is seen on
the list of devices with
Bluetooth interface
The detector can
communicate via the
Bluetooth interface
Detector not available for remote control - No No
Detector is always seen but can communicate
only with the permanent magnet in place
No
Yes
No
Yes Yes
Detector is seen and can communicate only
with the permanent magnet in place
No No No
Yes Yes Yes
Detector is always seen and can communicate - Yes Yes
Table 7: Operation modes of gas detectors with the Bluetooth interface
The picture below depicts how to mount the permanent magnet on the detector housing (only strong
neodymium magnets are suitable).
Be careful to mount the permanent magnet correctly with right orientation of poles.
Figure 8: Gas detector with a permanent magnet in place
Upon communication between the gas detector and the control software is established, the permanent
magnet can be removed.
5 Life cycle
5.1 Transportation
The device can be shipped in the same way as new equipment of that type. If the original package or
another protecting means (e.g. corks) is unavailable the conveyed equipment must be secured against
shocks, vibrations or moisture by means of adequate methods and material at the own responsibility of the
sender.
The device can be conveyed under environmental conditions as described in Table 10.
s. 14|27
User Manual: POD-064-ENG R05
Permanent magnet