4
3
III.
Installation and wiring
3.1.1 Open the packaging, you’ll see a charge point, a mounting bracket, a user manual and
a bag of mounting accessories. There is also an RFID card if the charge point is RFID version.
For cabled version, a cable hooker is also included inside.
3.1
Installation
on the ground
3.1.2 The chargepoint must be installed on a hard surface, concrete surface is recommended,
it can also be mounted on a solid ground. Drill hols according to the requirements marked on
the illustration for fixing expansion bolts.
3.1.3 Fix the chargepoint onto the holes with expansion bolts. The input cables shall go into
the pole from the bottom middle area and come out of it from the area below the cable
hooker.
3.1.4
Crimp the below shown ring terminals on the end of the AC input wires and PE wires.
Connect the wires into the terminal block of the chargepoint as below.
Check the wiring and then close the switch and the door.