ATEQ F600HP, Quick Start Manual

Page: 29 / 34

QSG_F600HP_425.00_EN_01_2021-01-25
29 / 34
PARAMETERS menu
Use this menu to configure the measurement cycle associated to each test program.
Default parameters of the type tests
Label Parameter Description
COUPL. A Coupling time Waiting time before filling the test part
FILL TIME Fill time Time to pressurise the part under test
STAB TIME Stabilization time Time to stabilise the pressure on the test and
reference parts
TEST TIME Test time Time for leak measurement
DUMP TIME Dump time Time to vent the part to atmosphere
Press. UNIT Pressure units Pressure unit (Pa, kPa, MPa, bar, mbar, PSI,
mmHg, inHg, Pts)
Max FILL Maximum fill pressure Maximum level of the fill pressure
Min FILL Minimum fill pressure Minimum level of the fill pressure
LeakUnit Reject unit Measurement units (kPa, kPa/s, MPa, bar, mbar,
PSI, cm
3
/s, cm
3
/min, cm
3
/h, mm
3
/s, ml/s, ml/min,
ml/h, l/min, H
2
0 µG/min, Pts)
Test FAIL Test fail Upper leak rate limit for the test part. Above this
limit, the part is considered as defective.
FUNCTIONS Functions Access to additional functions
Some parameters are displayed when specific functions are activated
.
Label Parameter Description
INTER-CYCLE Inter cycle time Time between two automatically chained
programs (Sequence function)
OFFSET Leak offset Leak offset value
REJECT CALC. Reject calculation Define raw unit to calculate flow unit (Flow unit)
Set FILL Set fill Fill pressure instruction (Fill function or
electronic pressure regulator)
VOLUME Test volume Complete volume of the test part (Flow unit)
Volume UNIT Volume unit Volume unit of the test part (Flow unit)
Max Fail Maximum fail Test FAIL is replaced by this one when the function
Flow Level = YES
Min Fail Minimum fail Appears when the function Flow Level = YES
Test REWORK Test rework
Test for specific reworkable parts