VE829 User Manual
18
Naming Source Devices
You can give names the input source devices attached to the VE829T
(Transmitter) to easily identify them. To do this, follow these steps:
1. Press and hold the
Source
button on the top panel of the VE829T for over
3 seconds.
2. In the screen that appears on your HDMI display, input the name you want
to give the input source device. Do this pointing the remote control at the
VE829T and using the
Up
and
Down
keys to change the letters / numbers;
use the
Left
and
Right
keys to move the cursor. The
IR
key serves as a
backspace.
3. Save the input source device name by either pressing the Source key on
the remote control or on the top panel of the VE829T.
The name should appear on screen when the input source device is selected for
both Transmitter and Receiver sides.
Note:
Refer to
, page 23 for steps on using the
Transmitter No.
button to change the Transmitter name.
Device Pairing
If you want to link another VE829T (Transmitter) with an existing VE829R
(Receiver), do the following steps:
1. Enter the Pairing mode for the VE829T. Power off the unit by unplugging
it.
2. Press and hold down the
Power
button. Plug the unit but keep pressing the
Power
button until the LED is blinking orange indicating that the VE829T
has entered the Pairing mode.
3. Do the same steps for the VE829R. Once the receiver enters the Pairing
mode, the screen shows a progress bar.
4. Once the pairing is finished, both units reboot and are ready to work
together.
