ATEN IOGear GWHDMS52, User Manual

Page: 18 / 32

Note: Pressing “Up” or “Down” on receiver
side or pressing “Left” or “Right” on
transmitter side will not initiate switching.
OSD Displayed:
18
B. Remote Arrow Keys Switching
• Transmitter side: Press By pressing the “ Up ” or “ Down ” arrow keys on the remote
control, it will pop up the on-screen display and allow you to cycle through each
input. Stop on the one you wish to watch and it will switch to that direct input /
source device.
6. When the GWHDMS52 is first powered on, the input default is set to Source 1. Note
that any time a source input is switched, it will take approximately 15 ~ 20 seconds for
the image to appear. There are 3 ways to switch between connected source devices as
follows:
Receiver Source Switch Left/Right arrow buttons
Transmitter Source Switch Up/Down arrow buttons
A. Press the SOURCE button on the top of the receiver or transmitter to switch the source
inputs until you see the desire video program being broadcasted from your source
device.
• Receiver side: By pressing the
“ Left ” or Right ” arrow keys on the
remote control, it will pop up the
on-screen display and allow you
to cycle through each input. Stop
on the one you wish to watch and
it will switch to that direct input /
source device.
C. Remote Control Source Button: Press the SOURCE button on the remote control to
directly switch between connected input sources. Keep pressing the SOURCE button
until the desired input source is selected.