3
1. GENERAL INFORMATION
1.1. INTRODUCTION
This user’s manual contains information about the machine and its operation.. Each machine operator should
read these instructions carefully, and the machine should be operated after fully understanding them.
Safe and efficient use of the machine for long term depends on understanding and following the instructions
contained in this manual. The technical dtawings and details contained in this manual constitute a guide for the
operator.
1.2. DISTRIBUTOR
ATech Machine, Inc.
8539 Ziggy Lane, Gaithersburg, MD 20877 – USA
Ph.: +1-240-505-1967 * Fax: +1-301-560-6627
*In case of any technical problem please contact your nearest ATECH dealer or ATECH head office through
the above mentioned phone, fax numbers or e-mail address.
*Technical labels with the model description of the machine are attached onto the front side of each machine.
*
The machine serial number, motor data, air pressure, air consumption and production date are printed on the
technical label.
2. DEFINITION OF THE MACHINE AND ITS USE
2.1. DEFINITION OF THE MACHINE
This heavy duty upcut miter saw has been designed for cutting of aluminum & vinyl extrusions and wood. Cuts can
be made both straoght and miter cuts. The operator adjusts the rising speed of the saw blade
(see Figure 1)
)
depending on the material to cut.
Miter cuts at 15
0
- 22,5
0
-30
0
-45
0
-90
0
are set via lock pin. Any intermediate angles are manually set by
tightening a bolt located on the turntable. You can also cut at 90
0
on the right side again with spring set.
The machine has been designed in full conformity with UL, CSA and CE Safety Directives.
The fence on the saw table consists of 2 parts, and can be moved back to allow larger straight cuts.
Rising speed of the saw blade is adjustable via know located on the left side, next to the control panel.
If the top guard is opened during the cutting process the saw blade stops and returns to its starting position
automatically for operator’s safety.
After the cutting process is completed, or once you release the cutting start buttons the saw blade moves
down o its starting position automatically.
STANDARD ACCESSORIES
Ø450 mm (18”) Carbide Tipped Saw Blade
Air Gun
Twin vertical & horizontal pneumatic clamps
Chip collector connection manifold
User’s Manual
OPTIONAL ACCESSORIES
Pneumatic Spray Mist Lubrication System
Infeed/Outfeed Table
Please mention the data below in every correspondence with your ATech Dealer or ATech Head Office.
Machine model
Machine’s serial number
Voltage and frequency
Name of dealer where machine was purchased
Date of purchase
Description of the machine fault
Average daily operation period
