12
3.3.16. Repairs should be carried out by qualified technicians only. Otherwise, accidents amt occur.
3.3.17. Before starting a new operation, check the appropriate function of protective devices and tools, ensure that
they work properly. All conditions have to be fulfilled in order to ensure proper operation of your machine.
Damaged protective parts and equipment have to be replaced or repaired properly (by the monufacturer or
dealer).
3.3.18. Don’t use machines with improper functioning buttuons and switches.
3.3.19. Don’t keep flammable, combustive liquids and materials next to the machine and electric connections.
3.4. SAFETY SYMBOLS AND MEANINGS
Electric warnings.
Use protective goggles.
If main connection cable is
damaged during operation, do not
touch it and disconnect the main
plug from main socket.
Use protective earmuffs.
When machine is working, do not
make your hand close to saw blade.
Use protective gloves when
changing the saw blade.
Keep working environment clean,
dry and tidy.
Read operating instructions
carefully before using or
maintaining the machine.
4. TRANSPORT OF THE MACHINE
* The transport should be done by qualified personnel only.
4.1.1.
The machine should be transported by lifting with proper equipment (not touching the ground during the
transport).
4.1.2. The machine is delivered wrapped in nylon and packet in carton box, unless other form of packing is agreed
upon with the customer.
4.1.3. For the weight and overall dimensions of the machine see Technical Features.
5. INSTALLATION OF THE MACHINE
The position of the machine should be at least 50 cm (20”) from the rear wall so that the protective top guard can
be fully opened to the rear and the machine maintenance activities can be carried out properly. For Left and Right
side surfaces, look at the Dimensions page for the distance that must be left between the wall and the machine.
5.1. PREPARATION
5.1.1. The overall dimensions of the machine are indicated on the Dimensions page. The surface on which the
machine is to be placed must be a solid flat surface and a floor to carry the weight of the machine.
5.1.2. CRATER All parts in cutting machines are ready for use by the manufacturer.
5.2. ELECTRICAL CONNECTION
5.2.1. The three-phase electrical wiring has to be done by a qualified electrician only.
5.2.2.
Check your input power before supplying power to the machine.
5.2.3. Make the electrical socket connections to position 0 of MAIN SWITCH on the machine.
IMPORTANT
