AWMS-2-D13-C | Page 9 of 13
AWM-LC Page 2 of 2
1.
Fix Clamp to Post or Wall Channel
3.
Fit AWM Series arm to Post Clamp
1.1
Ensure knob is undone.
2.1
Remove plastic sleeve.
3.1
Push arm onto clamp.
1.2
Slide Post Clamp into channel.
2.2
Remove rotation ring
3.2
Ensure arm is fully pushed onto clamp.
Push knob to
aid insertion
1.3
Hold clamp in desired position on post
and turn knob to lock in place.
2.3
Place rotation ring in the desired position.
3.3
Tighten joint screw.
Note:
Check the
arm rotation is
smooth after
tightening.
Note:
Arm sold
separately
Note:
Place the rotation ring
depending on what post channel
the arm will be attached to. The tag
should always face towards the user.
1. Ensure Knob is undone
1. Remove plastic sleeve
Tip: push knob
to aid insertion
2. Slide post clamp into channel
2. Remove rotation ring
1. Press
2. Lift
3. Hold clamp in desired position on post and turn
knob to lock in place
3. Place the rotation ring
in the desired postion
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20180518A - E02
180°
360°
OR
Default
Position
Flipped
Position
Tag
1. Push arm onto clamp
2. Ensure arm is fully pushed onto clamp
3. Tighten set screw
Tip: Check the
arm rotation is
smooth after
tightening.
2.
Set arm rotation to 180° (optional)
Note: default arm rotation is set to rotate 360�
