AWMS-2-BT75-G Page 4 of 4
Please Recycle
7. Fine Adjustment
6. Attach top display
ii
iii
iv
i
LHS &
RHS
TOP &
BOTTOM
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice.
©20221125A
6.1
Check that distance
between brackets is
equal to or greater than
the height of the display.
Repeat Step 5 to attach
top display and set tilt
angle.
Lower
Close
Adjust angle
Set angle
i
ii
iii
iv
WARNING:
Always remove display
before
adjusting height
Unstacked
Stacked
Cables can
exit from
the side of
the cable
cover
PUSH
PUSH
PUSH
8. Cable Management
8.1
Load cables into
cable clip.
8.2
Insert one side of the
cable clip into a channel
on the post, then push in
the other side.
Load cables into
cable cover
8.3
Load
cables into
cable cover.
8.4
Clip the cable cover
back onto rear post
channels.
7.1
To correct horizontal angle
of d/- 3 °:
Turn a single fine tune
adjustment knob to adjust
angle of screen.
Clockwise = Higher
Anti-clockwise = Lower
7.2
To close small gap between
di/-6mm (1/4”):
Turn both fine tune adjustment
knobs - alternating sides a few
rotations at a time.
Clockwise = Higher
Anti-clockwise = Lower
ii
iii
iv
i
LHS &
RHS
TOP &
BOTTOM
FINE HEIGHT ADJUST
FINE ADJUSTMENT
KNOBS
NOTE:
Ensure clips are in
CLOSED
position
