AWMS-2-BT75-G Page 3 of 4
5. Attach bottom display
5.1
Set VESA plate to
open
position.
Bottom display must be
attached to bracket first.
WARNING:
Use two people to install
display
OPEN
WARNING:
Do not loosen
hand knob once
display attached
5.4
Set VESA plate to
closed
position by sliding clips on
both sides inwards.
5.5
Adjust display tilt
angle by gripping edges
of screen and rolling up or
down to desired position.
OPEN
TILT KNOBS
5.6
Set display
angle by tightening
tilt knobs.
M
OPTIONAL
ADJUSTMENT -
TILT FRICTION
Clockwise = More friction
Anticlockwise = Less friction
4mm hex key can
be used to reduce
tilt friction (for
light screen) or
increase tilt friction
(for heavy screen)
5.3
Centre VESA plate
close to post and slowly
lower until bar on VESA
plate sits in saddle in
bracket.
5.2
Lift display until
VESA plate is above
the bracket.
CLOSED
4. Slide brackets onto post and set height
4.1
Line up the inner guide
on rear of bracket with rear
channel on post.
Slide inner guide into channel,
then lower bracket.
C
TIGHTEN
WARNING:
Never loosen knob while
display is on bracket
C
MEASURE
≥
Display
height
between
brackets
H
MEASURE
to
ensure clearance
to desk
4.2
Firmly tighten hand knob at
chosen height.
Ensure height is sufficient for
display to clear desk once in place.
Repeat with second bracket and fit
post cap.
MEASURE
≥
Display
height
between
brackets
H
MEASURE
to
ensure clearance
to desk
