AD-TVC-75 Page 2 of 4
1.
Install the castors
1.1
1.2
WARNING!
! CART CAN TIP OVER RESULTING IN RISK OF INJURY!
! DO NOT ALLOW CHILDREN UNDER 16 TO PLAY WITH OR MOVE CART
! MOVE CART SLOWLY
DO NOT PULL
NEVER APPLY FORCE
AT TOP
APPLY FORCE ON
NARROW SIDES
PUSH NEAR MIDDLE
DO NOT APPLY
MOVING FORCE ON
FRONT OR BACK
ONLY ADULTS SHOULD
MOVE THIS CART
LOCK
BRAKES WHEN
STATIONARY
UNLOCK
BRAKES BEFORE
MOVING
DO NOT PULL
NEVER APPLY FORCE AT
TOP
APPLY FORCE ON
NARROW SIDES
PUSH NEAR MIDDLE
DO NOT APPLY MOVING
FORCE ON FRONT OR
BACK
ONLY ADULTS SHOULD
MOVE THIS CART
LOCK
BRAKES WHEN
STATIONARY
UNLOCK
BRAKES BEFORE
MOVING
2.
Attach column to the base
D2
A2
Base bottom
B2
E2
2.1
2.2
2.3
Note: Make sure
cable management
windows are facing
the rear of base.
Caution: Ensure
screws are secured firmly.
3.
Set column height
Right
upper
column
Right
lower
column
Spring
button
Safety
screw
Left
lower
column
Left
upper
column
E2
Safety
screw
Spring
Button
E2
3.1 Unscrew safety screw on right
lower column using 6mm Allen key.
Put safety screw aside.
3.2 Use thumb or finger to depress
the spring button located on the right
lower column (Near cable window). At
the same time use other hand to twist
then pull right upper column upward
until your desired height. Twist motion
is to ensure spring button doesn’t
engage unintentionally. Twist upper
column back toward the plunger holes
and engage spring button into the
plunger hole. You may need another
person to help. (Fig-1)
3.3 Ensure spring button pops out and
secure safety screw. (Fig-2)
3.4 Repeat steps 1, 2 and 3 on left
column.
Fig-1
Fig-2
