13
OFF
ON
Open Window
OK
Wed. 11:00h
21
.5°C
Set point:
OFF
ON
Self Adaptive
OK
OFF
ON
EASY mode
OK
OFF (100%)
75%
50%
20%
LowSurfaceTemp
OK
Wed. 11:00h
21
.5°C
Set point:
COMFORT
EASY
Wed. 11:00h
21
.5°C
Set point:
set temp
Status ON
Change
Password
OK
Runback Config
Setback
Max. Temp.
OK
Runback
Confirm
OK CANCEL
RESET
LST 23%
Wed. 11:00h
21
.5°C
Set point:
The Open window setting
will turn the heating of the
convector off if the unit
detects a rapid drop in
temperature over a short
period of time.
To re-activate the heating
if the open window function
has activated press any
button the convector.
If the temperature rises
above the minimum detected
temperature then the heater
will reactivate and turn the
open window function off (i.e. the window was
closed).
If this function comes on frequently e.g. in an
area where there is an external doorway, it is
recommended to turn the open window function
off.
The Self Adaptive setting
will allow the convector to
calculate the optimum time
to start the heating cycle
when running in Program
mode.
If this setting is turned
on it will be shown in the
Notification area and the
heating will come on before
the programmed starting
time so that the room is at
the correct temperature
at
the programmed starting
time.
The
Low
Surface
Temperature (LST) menu
will allow the output of the
heater to be limited to a lower
setting to prevent the surface
of the heater becoming too
hot. If a surface temperature
of less than 43°C is required
use the lowest setting.
It is recommended that if
the LST function is activated
then the convector should be
locked with a non-standard
password after activation to
prevent the function being
turned off.
(See Password Section for details on changing
the factory default password)
EASY Mode is a simple
mode of operation where
by only the + and – buttons
on the convector operate to
increase or decrease the
temperature. The OK button
is de-activated. To turn the
convector on or off use the
Main power button on the
side of the heater.
When running in Easy
mode the screen will show
EASY in the notification area
to let the user know that the
mode is active.
To exit EASY mode press
and hold the CONFIG button
for 10 seconds, then select
“off”.
Runback: See Runback
Section on page 14
Password: See Password
Section on page 14
Resetting the convector
will return all settings to the
factory defaults and will also
delete any ‘pairing’ with a
Gateway.
To activate the RESET
feature select with arrow buttons OK, and press
the OK button.
The first press of any button will wake up the convector any
further button presses will activate the function required.
