4 :
C o n n e c t i o n
C1C and C3C Centre Channels
The C1C and C3C are equipped with a “bi-wire” connection
panel that enables separate amplification of the bass drivers and
tweeter. Remove the linking bars between the two pairs of
terminals if you wish to take advantage of the bi-wire facility.
The terminals can accommodate either stripped cable ends or
4mm plugs. Always use good quality speaker cable with a 2.5mm
2
minimum cross sectional area per conductor (79 strand). Cable
of a smaller cross sectional area or fewer strands is unsuitable.
For cable runs longer than 5m use a significantly heavier gauge
cable. Consult your dealer or consultant for specific cable
recommendations.
Ensure that the positive and negative terminals on each
connection panel are connected back to the corresponding
positive and negative terminals on the amplifier.
C1 Sub
The Subwoofer is provided with both line level inputs via a pair
of phono connectors and hi-level (speaker level) inputs on a
pair of binding posts. Only one type of input should be used
at any one time. The rear panel also features the mains power
input, power switch, fuse, filter controls and L+R Output for
connection to a second C1 sub. The amplifier standby/limiter
indicator is mounted on the smaller front panel.
Audio Input Options – C1 Sub
Line Level Inputs:
These should be used to connect your
subwoofer to preamp outputs or integrated amplifier preamp
outputs. For stereo use, use both connections. In a 5.1 system,
only connect to one input. Either left or right is fine and will
give the same results.
Hi-Level Inputs:
These should be used to connect your
subwoofer directly to a stereo pair of speakers, either via the
amplifier outputs or the loudspeaker input terminals themselves.
Take care to maintain correct polarity throughout.
ENTRY MANUAL 040919_ENTRY BROCHURE 13.3 10/09/2019 15:19 Page 16