ATC Electrical & Mechanical,
ATC House, Broomhill Drive, Tallaght, D24 EF99, Ireland
IE: 01 4678301, UK:0203 564 9164, Email [email protected]
-3-
INSTALLATION
1. Mark the wall using
the mounting bracket
as a template and
ensure the mounting
distances (left) are
observed.
2. Drill the wall and
install the plastic
anchors.
3. Attach the mounting
bracket with the screws
provided.
4. Mount the dispenser onto the
bracket by aligning the 2 clips and
lower onto the bracket.
5. Install the anti-theft screw, then
the battery holder and finally the
battery holder screw.
FILLING AND OPERATION
1. Once the unit is installed on the
wall, insert the locking key and
twist to unlock the cover. Remove
the cover to expose the sealing
cap.
2. Remove the sealing cap and fill
with liquid soap, alcohol sanitiser
or gel and replace the sealing cap.
Press and Hold the Control button
for approximately 3 seconds until
the LED flashes 3 times.
Each long press of the button turns
the unit on or off.
3. To activate the dispenser the user
should put their hand under the
unit until the sensor activates the
dispenser. Each time the dispenser
operates the LED will flash once.
Note: The initial operation may
take three or four operations until
product is dispensed.
Upper Slot
Upper Clip
Lower Slot
Lower Clip
1
2
Anti Theft Screw
Battery Holder
Screw
