background image

ATC Electrical & Mechanical, 

ATC House, Broomhill Drive, Tallaght, D24 EF99, Ireland 

IE: 01 4678301, UK:0203 564 9164, Email [email protected]

-1-

ATC Dahlia Hand Sanitiser Unit

Installation and Operation Manual 

Please read this installation and operation manual carefully before installing the unit.

Always use the same brand of AA battery and replace all batteries at the same time. Old and new batteries 

must not be mixed, doing so will damage the operation of the dispenser. 

Prior to installation please ensure that the mounting surface of the wall is flat and clean.

The minimum distance from the outlet of the unit to surfaces below the dispenser must be greater than  

250mm. 

Should the surface be highly reflective - such as polished stone or stainless steel- then the distance between 

the outlet and the surface must be increased to be greater than 350mm. 

If these minimum distances are not observed the automatic dispenser may operate whilst it is unattended. 

Highly reflective objects such as mirrors should not be put in the sensing range under the unit, nor should 

they be left on the counter underneath the dispenser.

This automatic dispensing unit must only be used indoors.

These installation instructions should be given to the user and kept in an accessible location after installation. 

Children should only use the dispenser under adult supervision to prevent  accidents. 

Do not throw away wasted batteries. Batteries must be recycled, please contact your local recycling center 

for further information.

The unit contains microcomputers, electronic circuitry, motors and valves. Do not splash or immerse in water. 

Clean with a soft cloth and neutral detergent. Do not use aggressive cleaning agents, detergents with micro 

particles, highly acidic or alkaline cleaning agents as they will damage the surface. Any such damage is not 

covered under the warranty. 

Be especially careful not to damage the sensor window. 

IMPORTANT SAFETY INFORMATION

HANDSU

Summary of Contents for atc.ie HANDSU

Page 1: ...ces are not observed the automatic dispenser may operate whilst it is unattended Highly reflective objects such as mirrors should not be put in the sensing range under the unit nor should they be left on the counter underneath the dispenser This automatic dispensing unit must only be used indoors These installation instructions should be given to the user and kept in an accessible location after i...

Page 2: ...hed to dispenser on arrival please remove prior to installation Should any of the above items be missing from your dispenser please contact your supplier BATTERY INSTALLATION Prior to installing the ATC Dahlia Auto Dispenser on the wall remove the battery holder from the base of the dispenser and install 6 good quality AA batteries ensure the correct polarity in the battery holder Once the dispens...

Page 3: ...AND OPERATION 1 Once the unit is installed on the wall insert the locking key and twist to unlock the cover Remove the cover to expose the sealing cap 2 Remove the sealing cap and fill with liquid soap alcohol sanitiser or gel and replace the sealing cap Press and Hold the Control button for approximately 3 seconds until the LED flashes 3 times Each long press of the button turns the unit on or of...

Page 4: ...tinuously flashing Low battery voltage Change for new batteries LED On without product supply Sensor is active Check for reflective objects below unit and remove them if present Check to ensure sensor window is clean Insufficient product supply Short product supply time Adjust the amount of product supplied See above Product is too thick to dispense Change for less Viscous product Product dried ou...

Reviews: