10
Plug the small end of the USB cable into the USB port
labeled
on the right side of the headset base.
Plug the large end of the USB cable into a USB port on your
computer. Wait for your computer to indicate that it has
recognized the headset.
Plug the end of the lifter control cable into the
LIFTER
jack at
the back of the headset base.
Use the attached fastener to bundle all line cords neatly.
Make sure the
CORDED HANDSET CONNECTED
switch on
the right side of the headset base is set to
YES
.
Adjust the corded handset audio (see page 11) before you
install the handset lifter on the corded phone.
For instructions of installing the lifter, see pages 12-14. For
information about the internal and auxiliary ring detectors,
refer to pages 16-18.
For TL7810/TL7812, download and install the
AT&T
Softphone Call Manager
on your computer. The software is
available for download at
www.smbtelephones.att.com/downloads
. For
detailed installation and operating information, refer to the
Installation and Operation Guide
, available for download at
www.smbtelephones.att.com/downloads
.
-OR-
For TL7910/TL7912, install the
AT&T Softphone Call
Manager
using the
CD-ROM
provided in the package. For
installation and operation instructions of the software, refer
to the
Installation and Operation Guide
which can also be
found in the
CD-ROM
provided.
Refer to the
Audio settings
section in the
Installation and
Operation Guide
to configure the audio settings.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Headset base installation - TL7810/TL7812/
TL7910/TL7912
TL7810/TL7812/YL7910/TL7912 headset base installation (cont.)
Getting started
