Performing the Upgrade
4-9
Figure 4-4.
Universal Installation Kit
17. Position the drive for installation in slot 4 (left most). The black metallic
backing of the drive should be face up. The mounting rails prevent the cir-
cuitry from touching the work table and adjacent chassis components once
the disk is mounted in the MAP/40.
18. Locate on either side of the MAP/40 the bottom fourth set of slots just
behind the front of the peripheral bay. Screws provided with the bracket kit
will be used through the bottom slot to secure the drive to the MAP/40
peripheral bay area.
NOTE
:
Even though, there are two threaded holes located just above each
other, use only the bottom position to secure the disk drive/mounting
brackets inside the MAP/40.
Summary of Contents for Map/40
