Priority Call Signal
When a caller enters the Priority Calling Code from a touch tone phone,
the system “chirps” to alert you that you have a Priority Call. You’ll need to
provide select callers with the Priority Calling Code (preset to 999), in
order for them to use this feature.
1
Your caller dials your telephone number from a touch tone phone.
2
When the announcement begins to play, your caller can enter the
Priority Calling Code.
3
The system “chirps,” then pauses. This continues for up to 30
seconds, unless you answer the phone, or the system picks up
the call.
4
If you do not answer, your caller can press
5
to stop the Priority
Call signal.
Changing the Priority Calling Code
The Priority Calling Code comes set to 999, but you can change it to any
three-digit number from 500 to 999 following the directions below.
NOTE:
Do not use the same code as the Remote Access Code. If you set
the Priority Calling Code and the Remote Access Code to the same
number, neither Code will work.
1
Press
c
on the base.
2
Press and release
s
until you hear “
Priority Call Code is...
”.
The system announces the current Priority Calling Code.
3
Press
<
or
>
to change the first digit. Press
s
to
move to the second digit.
4
Press
<
or
>
to change the second digit. Press
s
to move to the third digit.
5
Press
<
or
>
to change the third digit. Press
s
to
save. The system announces the new Priority Calling Code.
Reviewing Feature Settings
You can check the status of the answering system feature settings by
pressing
s
on the base.
FEATURE SETUP
11
9355_book_1ATT 7/12/99 2:25 PM Page 11
