wwwAtairCanopies.com
Troll DW Canopy User Manual
Page 16 Atair Canopies
Figure
3a
Figure
3b
Ensure that there are no twists in the risers. Grasp the inner most line on both rear riser
links and then grasp the two lower control lines. Walk these four lines toward the
canopy. These four lines will cascade into 12* lines. These are the 12* lines that will be
placed into the Tail Gate. Make certain that there are no other lines caught up in
these 12* lines. Figure 3 represents the lines as viewed from the bottom surface of the
canopy. Be certain that only the lines that are encompassed in the ‘T’ are inside the
Tail Gate.
The C line that the Tail Gate is attached to MUST be inside the Tail Gate, so as not to
load the insert piece. Place all 12* lines into the Tail Gate. Close the Tail Gate with two
to three wraps of the rubber band, as shown in figure 3a and 3b. Check to be certain
that there are 12* lines in the Tail Gate and that the Tail Gate C line is inside the Tail
Gate. Go to section 7.3 to continue with the packing process.
*Note: The Troll DW comes standard with 4 brake lines, although can be ordered with 5
brake lines, in which case there will be 14 lines inside the Tail Gate.
