EN 10
Grease filters
Removing the grease filters
• Before you can remove the grease filters, you must open the edge-
extractor panel.
• Hook your fingers behind the panel and use your thumbs to lever it
away from the edge of the extractor hood.
• Flip the edge-extractor panel downwards.
• Release the latch cables by turning the bayonet catch 180 degrees
and allow the panel to drop down fully.
• Take hold of the grease filter using the handgrip and depress the
catch (1). Tilt the front side of the filter downwards (2). Now lift the
filter from the hood towards you
• Clean the grease filters (see “Cleaning the grease filters”) .
• Put the filter back into place by first pushing the rear side into
the holder. Keep the catch in the handgrip depressed and
simultaneously tilt the front side upwards as far as it goes and then
release the catch. The filter is now once again in place.
• Attach the latch cables to the edge-extractor panel and press the
edge-extractor panel into place.
MAINTENANCE
1
2
1
