GB 17
assembly
buiding in
wall mounting
1. Mark a centre line on the wall (1). Fit the template onto
the wall (2). Fix the drilling template to the wall.
2. Make 3 Ø 8mm holes in the wall (3a), 2 at upper points, 1
as desired at lower points.
Extraction mode only
If you wish to use the rear exhaust outlet on the hood, make
a hole in the wall so that the exhaust pipe can pass through
it (3b).
3. Insert the three Ø 8mm expansion plugs into the wall (4)
(brick fixing only).
4. Insert 2 5x45 screws (5) but do not tighten them
completely. Hang the hood (6).
5. Tighten the 2 upper screws (7).
6. From inside the hood, insert the third 5 x 45 screw into
the lower hole (8) and tighten (9).
88028282 HL WO60.qxd 09-06-2009 11:04 Pagina GB 17
