Atag VA2113QT, Operating Instructions Manual

Page: 68 / 156

Action Possible causes Problem
Check that the salt compartment
lid is properly tightened.
Otherwise call the service
department. The water softener is leaking
salt. Spots or films on the dishes.
See the chapter Settings. Incorrect water softener setting.
See the chapter Settings. Incorrect rinse aid dosage
setting.
Top up with salt. See the
chapter Before washing for the
first time. Salt compartment empty.
Inactivate the setting TAB
(3-in-1/ All-in-one detergent) and
top up salt and rinse aid. 3-in-1/ All-in-one detergent is
used and the setting TAB
(3-in-1/ All-in-one detergent) is
activated.
Wash crystal at a low
temperature and with a
conservative amount of
detergent. Contact the detergent
manufacturer. Too high temperature and/or too
much detergent can cause
etching on crystal.
Unfortunately, this cannot be
repaired, only prevented.
Reduce the amount. See the
sections Before washing for the
first time and Settings. If you
have very soft water, you may
want to dilute the rinse aid 50:50
with water. Rinse aid dosage setting too
high. The dishes have a sticky
white/blue film.
Use a detergent with a
bleaching agent. Lipstick and tea can be difficult
to wash off. Spots left after washing.
The detergent compartment
must be dry when adding
detergent. The detergent compartment was
damp when adding detergent. Detergent residue in the
detergent compartment after
dishwashing.
Check that the dishes are
placed securely. Spin the spray
arms to make sure they can
rotate. The dishes are not correctly
placed or the spray arms are not
rotating. Rattling sound when
dishwashing.
Table continued from last page
28
Troubleshooting