Atag DX6411B, Manual

Page: 237 / 242

EN 59
Changing the lamp
• Danger of electric shock!
Before replacing any of the oven light bulbs, take the
following steps:
• Switch off the oven.
• Disconnect the oven from the mains.
• Protect the oven light bulb and the glass cap by laying a cloth on
the bottom of the oven compartment.
Bulbs can be purchased from the ATAG Customer Service.
Replacing the rear oven lamp and cleaning the glass cap
1. Remove the cap by turning anticlockwise and remove the
metal ring, the sheet ring and clean the glass cap. If necessary,
replace the bulb with a 25 ~ 40 watt, 230 V, 300 °C heat-
resistant oven light bulb.
2. Clean the glass cap, the metal ring and the sheet ring if
necessary.
3. Fit the metal and the sheet ring to the glass cap.
4. Place the glass cap where you have removed it in step 1 and
turn it clockwise to keep it in place.
Replacing the oven side lamp and cleaning the glass cap
1. To remove the glass cover, hold the lower end with one hand, insert
a fl at sharp implement such as a table knife between the glass and
the frame and pop out the cover.
2. If necessary, replace the halogen bulb with a 25 ~ 40 watt,
230 V, 300 °C heat - resistant halogen oven light bulb.
Tip
• Always use a cloth when handling a halogen bulb to avoid
depositing oils from your fingers on to the surface of the bulb.
3. Replace the glass cover.
CLEANING AND CARE