10
Installation
Installation on M-2000 Series or X-1000 Series Systems
"
NOTE
Illustrations in this subsection show the DV-8000, but installation instructions also apply to
DV-7000 Series Pumps.
1. Use the position controls to move the dispensing head to the front center of the dispensing area.
2. Perform a service shutdown and lock out/tag out power to the dispensing system as specified in
the applicable dispensing system manual.
3. Use a 3 mm hex key to attach the valve bracket to the valve mounting plate (Figure 3-6).
!
Position the valve bracket on the mounting plate so that when the pump is installed it will not
collide with components when moving around the dispensing area.
Figure 3-6 Attaching the Valve Bracket
(M-2000 shown)
Figure 3-7 Mounting the Valve (M-2000 shown)
4. Slide the pump into the valve bracket (Figure 3-7).
5. Use a 4 mm hex key to tighten the locking screw on the side of the valve bracket.
!
The pump should be tightly held by the bracket.
"
NOTE
If you will be using a height sensor, proceed with Step 6. If not, skip to Step 8.
6. Use a 3 mm hex key to attach the height sensor bracket to the valve bracket (Figure 3-8).
7. Use a Phillips head screwdriver to attach the height sensor to the height sensor bracket
(Figure 3-9).
Valve
Mounting
Plate
Bracket Mounting
Screws
Valve Bracket
