2-18
Chapter 2: Basic installation
7. Carefully push the optical drive all
the way into the bay until the optical
drive lock clicks.
8. Connect a 4-pin power plug from
the power supply unit to the power
connector at the back of the drive.
Uninstalling the optical drive
In the future, you may have to upgrade or replace a defective optical drive.
To uninstall the optical drive:
1. Remove the front panel assembly following the instructions in section “2.3.2
Removing the front panel assembly”.
2. Locate the optical drive screw lock.
4. Disconnect the IDE, audio, and
power cables and plugs from the
back of the drive.
5. Pull out the drive completely from
the bay, then replace it following
the instructions in the previous
section.
A
B
3. Push the lock to release the optical
drive screw (A), then slightly pull
the drive out from the bay (B).
Summary of Contents for P3-P5G33 - P Series - 0 MB RAM
Page 98: ...5 34 Chapter 5 BIOS setup ...
