ASUS P2Z-VM User’s Manual
41
IV. BIOS SETUP
6. BIOS Setup
IV
. BIOS SETUP
BIOS Setup
The motherboard supports two programmable Flash ROM chips: 5-Volt and 12-
Volt. Either of these memory chips can be updated when BIOS upgrades are re-
leased. Use the Flash Memory Writer utility to download the new BIOS file into the
ROM chip as described in detail in this section.
All computer motherboards provide a Setup utility program for specifying the sys-
tem configuration and settings. If your motherboard came in a computer system, the
proper configuration entries may have already been made. If so, invoke the Setup
utility, as described later, and take note of the configuration settings for future refer-
ence; in particular, the hard disk specifications.
If you are installing the motherboard, reconfiguring your system or you receive a
Run Setup message, you will need to enter new setup information. This section
describes how to configure your system using this utility.
The BIOS ROM of the system stores the Setup utility. When you turn on the com-
puter, the system provides you with the opportunity to run this program. This ap-
pears during the Power-On Self Test (POST). Press <Delete> to call up the Setup
utility. If you are a little bit late pressing the mentioned key(s), POST will continue
with its test routines, thus preventing you from calling up Setup. If you still need to
call Setup, reset the system by pressing <Ctrl> + <Alt> + <Delete>, or by pressing
the Reset button on the system case. You can also restart by turning the system off
and then back on again. But do so only if the first two methods fail.
When you invoke Setup, the CMOS SETUP UTILITY main program screen will
appear with the following options:
Summary of Contents for P2Z-VM
Page 1: ...R P2Z VM Pentium III II CeleronTM Motherboard USER S MANUAL ...
Page 61: ...ASUS P2Z VM User s Manual 61 R SUPPORT CD ...
Page 95: ...ASUS P2Z VM User s Manual 95 This page was intentionally left blank ...
Page 96: ...ASUS P2Z VM User s Manual 96 This page was intentionally left blank ...