Asus P2B-VM, User Manual

Page: 31 / 96

ASUS P2B-VM User’s Manual 31
III. INSTALLATION
13. Chassis, CPU , & Power Supply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN)
These connectors support cooling fans of 500mAMP (6 Watts) or less. Orien-
tate the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan’s plug to the board taking into consid-
eration the polarity of the this connector. NOTE: The “Rotation” signal is to
be used only by a specially designed fan with rotation signal.
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
P2B-VM 12-Volt Cooling Fan Power
Chassis Fan Power
Power Supply Fan
GND
Rotation
+12V
GND
Rotation
+12V
CPU Fan Power
GND
Rotation
+12V
R
14. ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply can supply at least 10mA
on the 5-volt standby lead (5VSB). You may experience difficulty in powering
on your system if your power supply cannot support the load. For Wake-On-
LAN support, your ATX power supply must supply at least 720mA +5VSB.
P2B-VM ATX Power Connector
+3.3V
olts
+3.3 V
o
lts
-12.0V
olts
+3.3 V
o
lts
Ground
Ground
Power Supply On
+5.0 V
o
lts
Ground
Ground
Ground
Ground
-5.0 V
o
lts
Power Good
+5.0 V
o
lts
+5V Standby
+5.0 V
o
lts
+12.0V
olts
Ground
+5.0 V
o
lts
R