A S U S A P 1 6 0 0 R - E 2 ( A A 2 / A I 2 )
A S U S A P 1 6 0 0 R - E 2 ( A A 2 / A I 2 )
A S U S A P 1 6 0 0 R - E 2 ( A A 2 / A I 2 )
A S U S A P 1 6 0 0 R - E 2 ( A A 2 / A I 2 )
A S U S A P 1 6 0 0 R - E 2 ( A A 2 / A I 2 )
6 - 1 9
6 - 1 9
6 - 1 9
6 - 1 9
6 - 1 9
6.1.4.6
6.1.4.6
6.1.4.6
6.1.4.6
6.1.4.6 Rebuilding a RAID set
Rebuilding a RAID set
Rebuilding a RAID set
Rebuilding a RAID set
Rebuilding a RAID set
The utility displays the condition of the RAID set during the POST. When a
RAID set is degraded, you can use the utility to rebuild it.
To rebuild a RAID array:
1.
Enter the Adaptec RAID Configuration Utility following the instructions
in the section “Creating a RAID 0 (Stripe).”
2.
Select A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y from the initial menu, then
press <Enter>.
Check the physical connections of the SATA hard disk drives before you
rebuild a degraded RAID set. Check the system and motherboard user
guide for additional information.
3.
From the main menu, highlight Manage Arrays, then press <Enter> to
display the installed RAID sets.
4.
Highlight the degraded RAID set, then press <Enter> to display the
array properties. The A r r a y S t a t u s
A r r a y S t a t u s
A r r a y S t a t u s
A r r a y S t a t u s
A r r a y S t a t u s shows DEGRADED.
Summary of Contents for AP1600-R-E2
Page 10: ...x ...
