9
SYSTEM EQUIPPED WITH AN ADDITIONAL SENSOR
.
If your system is equipped with a sensor designed to monitor the status of the trunk (added at time of installation), the parking lights will flash three times to
confirm that the command was received. When the trunk is released, 3 chirps are emitted to warn that the alarm will not take into account the status of this zone
or the shock sensor's zone for the next 5 minutes. If you do not release the trunk within 10 seconds, the system will rearm the trunk automatically.
The timer is reset each time the command is repeated, which allows a new 5-minute period to close the trunk lid.
The system will sound a chirp when the trunk is closed to confirm it has been rearmed. If the trunk is opened for more than 5 minutes, the system switches to the
alarm status.
AUTOMATIC LOCK/UNLOCK
Programmable as Active or Inactive during installation.
This function locks the doors when the ignition key is in the RUN position, the engine is running and the brakes are applied.
The doors are unlocked when the key is turned from RUN to OFF, or when the Continuous Mode (Including Turbo Mode) is activated, or when a safety sequence
is detected.
If the Unlock function is set to unlock only the driver's door on the first command, the Automatic Unlock function will unlock the driver's door only. If the dome light
is connected to the system, it comes on when an Automatic Unlock occurs.
This function is: Active
Inactive
.
START COMMANDS
STARTING THE ENGINE
To start the engine, press the
button.
The system automatically adjusts the ignition duration for your type of vehicle (gas or diesel); the parking lights flash once (for four seconds) then stay on when
the engine is running.
If more than one command is sent, each successive start command resets the runtime. Parking lights flash once to confirm the command has been received and
the horn sounds once (programmable during installation) to let you know the engine is already running.
When the start command is transmitted,
the system immediately sends out one of two possible confirmations:
1.
the vehicle can start.
2.
the vehicle will not start
System starting
Large Remote
Start icon appears
on remote
The vehicle won't start if, for example, the hood is open. In this case, the
parking lights flash and the text field shows “remote start failed”. The start-
fail codes are available on page 19.
System not starting
Error code,
text field
The parking lights
flash and the text
field displays an
error code
If the vehicle starts, the system will automatically send another
confirmation, with a melody, after a few seconds. If Runtime display option
is selected, it displays the remaining runtime in the text field. Otherwise,
the clock time is displayed.
Successful start
Small Remote
Start icon and a
melody is played
IF THE ENGINE DOES NOT START
If your system cannot start the engine at the first attempt, it will wait a few seconds then try again. It could try again twice depending on failure reason.
After three attempts, it will shut down automatically and wait for a new command.
