3. Select Button
When measuring current, press the “SELECT” button two switch the meter
between DC and AC mode.
When measuring diodes and/or continuity, press the button to switch between
the two functions.
4. Data Hold / Backlight Button
Press this button to activate Data Hold. During Data Hold, the results will freeze,
even after there is no longer input into the multimeter. To turn off Data Hold,
simply press the button again.
Activate the Backlight by pressing and holding this button for 2 seconds. To turn
off the backlight, simply press and hold the button for 2 seconds again.
5. Max/Min Button
Press this button to display either the maximum or minimum value the multimeter
records during a measurement test. The maximum and minimum values will be
cleared after cleared when the test function changes or the meter is turned off.
6. Relative Test
Press this button to store the current reading and resets the display to ‘0’. Using
this function sets a relative reference point for the next reading.
This meter will display relative measurements in all functions except frequency.
7. Hz/Duty Button
This button switches between the Hz Function and Duty Cycle Functions.
When measuring AC Voltage, pressing this button will display the frequency of
the AC Voltage.
8. Function Select/Range Switch
Use this switch to select the desired function and range for measurement.
9. “A” Terminal
Plug-in connector for the red test lead for the Current Measurement Function
(200mA~10A).
10. “COM” Terminal
Plug-in connector for black (negative) test lead.
11. INPUT Terminal
Plug-in connector for the red test lead for all measurements except Current
(≥200mA).
