NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
6
7.
With one set of three leads, connect the green wire to a
lamp (
Figure 14
).
Figure 14: Attaching green wire to firebox liner backlight kit
lamp, and inserting lamp into bracket
8.
Insert the lamp (with green wire attached) into a bracket
until the spring clip is engaged (
Figure 14
).
9.
Connect the white (neutral) wire and black (hot) wire
(
Figure 15
).
Figure 15: Attaching black and white wires to firebox liner
backlight kit lamp
10.
Repeat the process in
step 4
through
step 6
for the two
remaining lamp assemblies.
11.
Insert the three (3) lamp assemblies in the exact orientation
shown (
Figure 16
).
Figure 16: Installing the lamp assemblies
12.
Secure the lamp assemblies using the six (6) previously
removed screws from the cover plates (
Figure 16
).
Backlight Wire
Routing Holes
Figure 12: Routing wiring
2.
If the firebox rear ledge has backlight wire routing holes,
proceed with the instructions in
Route and connect
optional firebox liner backlight kit wiring and install lamp
assemblies
below.
If the rear ledge does not have backlight wire mounting
holes, follow the instructions detailed in
Route and connect
optional firebox liner backlight kit wiring and install lamp
assemblies
on
Page 10
.
Route and connect optional firebox liner backlight kit
wiring and install lamp assemblies
1.
Remove the three (3) cover plates in the lower front face
of the back panel. Discard the cover plates, but retain
the screws.
Figure 13: Removing the cover plates, and routing the wiring
2.
Route one set of three leads (white/green/black) through
each backlight wire routing hole in the rear ledge
(
Figure 12
).
3.
Route one set of three leads (white/green/black) through
each hole in the lower front face of the back panel
(
Figure 13
).
