INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
Printed in U.S.A. © 2014 Innovative Hearth Products
P/N 900077-05 Rev. NC 09/2014
1508 Elm Hill Pike, Suite 108, Nashville, TN 37210
www.IHP.US.com
Innovative Hearth Products reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles, and products.
Consult your local distributor for fireplace code information.
P900077-05
APPENDIX: ALTERNATE INSTALLATION INSTRUCTIONS
Route and connect optional firebox liner backlight
kit wiring and install lamp assemblies
NOTE:
These instructions should be used in place of
Route
and connect optional firebox liner backlight kit wiring and
install lamp assemblies
on
Page 6
, for fireplaces without
backlight wiring kit routing holes as shown in
Figure 12
on
Page 6
.
1.
Route one set of three leads (white/green/black) through
the hole in the front of the bracket (
Figure 26
).
Front of Mounting Bracket
Figure 26: Routing wires through lamp bracket
2.
Connect the green wire to the lamp (
Figure 27
).
Figure 27: Attaching green wire to firebox liner backlight kit
lamp, and inserting lamp into lamp bracket
3.
Insert the lamp (with green wire attached) into bracket until
the spring clip is engaged (
Figure 27
).
4.
Connect the white (neutral) wire, and black (hot) wire
(
Figure 28
).
Figure 28: Attaching black and white wires to firebox liner
backlight kit lamp
5.
Repeat the process in
step 1
through
step 4
for the two
remaining lamp assemblies.
6.
Carefully lay the firebox backlight lamp assemblies and
wiring on the fireplace floor. The lamp assemblies will not
be installed until the back panel is installed (in a later step).
7.
Remove the three (3) cover plates in the lower front face
of the back panel. Discard the cover plates, but retain the
screws.
8.
Insert the three (3) previously assembled lamp assemblies
in the orientation shown (
Figure 29
).
NOTE:
The wires will be routed under the rear floor section
in the next step.
9.
Secure the lamp assemblies using the six (6) previously
removed screws from the cover plates.
Cover Plate
Note orientation of each
lamp assembly.
Figure 29: Installing the lamp assemblies
NOTE:
When installing the rear floor, route the firebox
backlight wiring through the notches under the rear floor
section. Be careful not to pinch or damage the wires.
