Astria Rhapsody42TEN Installation Instructions Manual Download Page 1

P900077-05

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

 DANGER

HOT GLASS WILL CAUSE BURNS. DO NOT 

TOUCH GLASS UNTIL COOLED. NEVER 

ALLOW CHILDREN TO TOUCH GLASS.

• 

Fireplaces surfaces get EXTREMELY HOT!

• 

Install only when fireplace is OFF and COLD.

• 

The glass on the front of the fireplace reaches 

EXTREMELY HIGH temperatures and can cause severe 

burns if touched. Even after the gas is turned off, 

fireplace surfaces remain extremely hot.

• 

Keep children away from an operating fireplace. Closely 

supervise children in any room where a fireplace is 

operating to prevent contact with glass. 

 

CAUTION

RISK OF PERSONAL INJURY OR PROPERTY DAMAGE. 

• 

Never operate fireplace without liner panels installed. These 

appliances are NOT approved for operation without liner panels.

• 

Do NOT abuse glass doors by striking or slamming shut

• 

Never operate fireplace with glass door assembly removed.

• 

Handle glass door assembly with extreme care. 

Replace damaged glass door assembly with approved 

replacement assembly only.

• 

Use only media approved for use with these fireplaces 

(as applicable). Failure to use approved media may result 

in sooting, delayed ignition, or other improper fireplace 

operation, and may void the warranty.

NOTICE

• 

Read all steps before starting installation. 

• 

LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.

• 

All warnings, precautions, and instructions in the Installation 

Instructions and Care and Operation Instructions provided 

with the appliance also apply to these instructions.

• 

If you encounter any problems, need clarification of these 

instructions, or are not qualified to properly install this 

kit, contact your local distributor or dealer.

Figure 1: 54 in. DRL and Rhapsody linear gas fireplaces 

with designer floor kit and Illusion Cityscape 

firebox liner kit (both in black porcelain).

HEARTH PRODUCTS

KITS AND ACCESSORIES

P/N 900077-05  

Rev. NC  09/2014

LINEAR DIRECT VENT FIREPLACES 

ACCESSORY KITS

INSTALLATION INSTRUCTIONS FOR REQUIRED AND OPTIONAL ACCESSORIES 

FOR USE ON 42- AND 54-INCH LINEAR DIRECT VENT GAS FIREPLACES

[FIREPLACE MODELS: 

Rhapsody42TEN and Rhapsody54TEN

]

GENERAL INFORMATION

This document contains installation instructions for the 

following required and optional accessories for Rhapsody

®

 

linear direct vent gas fireplaces manufactured by INNOVATIVE 

HEARTH PRODUCTS.
Kit descriptions, catalog/model numbers, and contents are 

listed on the next page. 

Required Accessory Kits

The following accessory kits are REQUIRED for complete 

fireplace installation.

NOTE: 

Ensure these kits are available before installing 

the fireplace.

• 

Firebox Liner Kit

• 

Floor Kit

• 

Media Kit *

*

Media kit required with “Designer" style floor kits only.

Optional Accessory Kits

The following accessories are OPTIONAL. However, to minimize 

required labor, all  options should be installed at time of 

fireplace installation, if possible.

• 

Surround Kit

• 

Bezel Kit

• 

Firebox Backlight Kit **

• 

Power Vent Kit  

(see manual 506022-01 for installation instructions)

**

Firebox backlight kit for use with "Cityscape" and "Illusion" style firebox 

liner kits.

REQUIRED TOOLS

NOTE: 

Power tools are NOT recommended when installing 

fireplace accessories, especially porcelain firebox liners.

• 

5/16 in. Hex-head Nut Driver

• 

#3 Phillips Head Screwdriver  

(for fireplace door removal/installation)

• 

Glass Cleaner (non-ammoniated)

• 

Non-abrasive rag

• 

High-temperature sealant  

(e.g., Mill-Pac

®

; if installing firebox backlight kit)

• 

Safety Glasses

• 

Protective Work Gloves

Summary of Contents for Rhapsody42TEN











Reviews: