Astria.us.com
900635-00A
10
Installing Batteries in Battery pack
1. Remove access cover on battery pack.
2. Install 4 AA batteries, included, into battery pack following
positive and negative directions.
3. Replace access cover on battery pack.
4. Place battery pack next control valve away from the burner.
Installing Batteries in Handheld Remote Control
1. Remove battery cover on back of remote control.
2. Install supplied A23/12V battery following positive and
negative directions.
3. Replace battery cover onto remote control.
Gas Meter
Figure 15 - Checking Gas Joints (Natural Gas Only)
Control Valve
Location
Equipment Shutoff Valve
INSTALLATION
Continued
1. Open equipment shutoff valve
(see
Figure 13, Page 9
)
.
2. Open main gas valve located on or near gas meter for
natural gas or open propane/LP supply tank valve.
3. Make sure control knob of appliance is in the OFF position.
4. Check all joints from gas meter to equipment shutoff valve
for natural gas or propane/LP supply to equipment shutoff
valve for propane/LP
(see
Figure 14, Page 9 or Figure
15, Page 10
)
. Apply noncorrosive leak detection fluid to all
joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light appliance
(see Operation,
Page 14
)
. Check all other
internal joints for leaks.
7. Turn off appliance
(see To Turn Off Gas to Appliance,
Page
14
).
INSTALLING BATTERIES IN HAND HELD REMOTE
CONTROL AND BATTERY PACK
Figure 16 - MF Series Burner System- Log Compatibility
Chart
INSTALLING LOGS AND VOLCANIC STONE
WARNING: Failure to position the parts in
accordance with these diagrams or failure to
use only parts specifically approved with this
appliance may result in property damage or
personal injury.
CAUTION: After installation and periodically
thereafter, check to ensure that no flame comes
in contact with any log. With appliance set to
Hi, check to see if flames contact any log. If
so, reposition logs according to log installation
instructions in this manual. Flames contacting
logs will create soot.
LOG PLACEMENT
It is very important to install these logs exactly as instructed.
Do not modify logs. Only use logs supplied with appliance or
as identified for use with the appliance as shown in
Figure 18
.
NOTE:
Each log includes an identifying number cast in the
log. Look at each log when placing them on the burner system
to be certain it is correct.
1. Find the right front log (SouthernComfort30 or
ShadyHollow30 inch models: D-019 or SouthernComfort36
and ShadyHollow36 inch models: D-027). See
Figures 17,
17A, 17B,
and
17C
for reference. The log has a rectangular
shape on the bottom that fits against the lip on the black
metal base, the square grate, and the round tube burner.
Slide the log in place as shown in Figures.
MF SERIES BURNER SYSTEM
LOG COMPATIBILITY CHART
Burner System Model
Refractory Concrete Logs
For Use With This Burner
System
MAGNIFLAMEOD30NE,
MAGNIFLAMEOD30PE
SOUTHERNCOMFORT30A/B
SOUTHERNCOMFORT36A/B
SHADYHOLLOW30A/B
SHADYHOLLOW36A/B
