Astria.us.com
900635-00A
15
OPERATION
Continued
Figure 25 - Turning Equipment Shutoff Valve to the OFF
Position
MAIN
IN
OUT
PILOT
ADJ
PILOT
Equipment
Shutoff Valve
Incoming
Gas Line
GAS CONTROL MODULE SYSTEM
REMOTE CONTROL FEATURE
The module has a built in remote control receiver that
allows the user to program the remote transmitter at
any time during or after the installation of the burner.
1. There is a switch located on the right side of the module
that reads REMOTE/OFF
(
Figure 26
)
.
2. When the remote/off switch is in the OFF position, the
burner will operate from the rocker switch or wall switch
connected to the two BROWN wires on the module.
3. When the remote/off is in the REMOTE position the burner
will operate from the Remote Control transmitter.
NOTE
:
The module must be programmed to the Remote
Control transmitter.
•
To program the module (make sure the system has
power), locate the learn button
(
Figure 27
)
on the module.
Locate the metal shield that is covering the module and
remove the screw on top. Use a small thin object like a
paper clip (not sharp points) to press and release the learn
button. There will be a beep sound from the module. Then
press any button on the remote transmitter. Once the
module's internal receiver accepts the transmitter code,
there will be a series of confirming beeps.
•
The remote system is ready for use.
•
Pushing and holding the LEARN button for 6 seconds
will result in clearing the transmitter security code from
the module's memory. The module will make three long
beeps in succession when it has been cleared.
Remote/Off Switch
ADJ.
“S” Pilot Connection
“I” Pilot Connection
AF-4000 MOD Module Rt Side
Figure 26 - Gas Module Right Side
AF-4000 MOD Module Lt Side
AUX Connection
Learn Button
Figure 27 - Gas Module Left Side
INSPECTING BURNERS
Check burner flame patterns often.
IGNITER ASSEMBLY
The igniter assembly is factory preset for proper ignition of
the burner. Alterations may have occurred during shipping
and handling. Call a qualified service person to readjust the
igniter assembly if necessary.
The igniter should be positioned as shown in
Figure 28
.
NOTE
:
Figure 28
, shows the correct positioning of the igniter
and sensing rod.
If your igniter assembly does not meet these requirements:
• turn appliance off (see
To Turn Off Gas to Appliance,
Page
14
).
• see
Troubleshooting
,
Page 18
Figure 28 - Igniter Assembly
Igniter
Igniter
Sensing Rod
Burner
Tube
Figure 29 - Correct Burner Flame Pattern
Yellow Flames with
Orange Streaks
BURNER FLAME PATTERN
Figure 29
shows correct burner flame pattern.
NOTICE: Do not mistake orange flames with
yellow tipping. Dirt or other fine particles are
burned by appliance, causing brief patches of
orange flame.
If burner flame pattern is incorrect, as shown in
Figure 30,
Page 16
.
• turn appliance off
(see To Turn Off Gas to Appliance,
Page
14
)
• see
Troubleshooting
,
Page 18
