Operation
900912-00C, 04/2019
Innovative Hearth Products
Gemini™ -C Series Direct-Vent Gas Fireplaces
60
Installing the glass door
1. Visually inspect the gasket on the backside of the glass door.
NOTE: The gasket surface must be clean, free of irregularities, and seated firmly. Ensure it is properly located.
Make sure the bead is not rolled into the channel at the top of the door, but remains flat against the top of the
glass.
2. Position the door in front of the firebox opening with the bottom of the door held away from the fireplace at a
45° angle (
Figure 47
). Hook the top flange of the door frame over the top of the firebox frame.
NOTE: Ensure the glass door is centered—with even spacing on each side.
3. Let the bottom of the glass door swing gently in towards the fireplace ensuring that the gasket seats evenly as
the door draws shut. Securely fasten the two (2) latches beneath the firebox floor to the door V-flange.
IMPORTANT NOTE: The door must close without force. When installed properly, the bottom of the door should
not have interference with the fireplace in order to close. If it does, remove the door and inspect the door gasket
to ensure it is even and not rolled up at the top. SEE WARNING IN
Figure 47.
4. Reinstall the facade that includes the required barrier.
Removing the glass door
1. If necessary, remove the door and place it in a safe location for later reinstallation.
2. Remove the facade. Place the facade in a safe location for later reinstallation.
3. Detach the two (2) door latches beneath the firebox floor.
4. Swing the bottom of the glass door away from the fireplace to a 45° angle (
Figure 47
)
5. Carefully grip the door at the top and bottom, and remove it from the fireplace. Place the door in a safe location
for later reinstallation.
Figure 47 - Glass Door
Figure 48 - Barrier
NOTICE: All Gemini-C series fireplaces
require a
facade kit (purchased separately), which includes
a barrier to reduce the risk of burns from the hot
viewing glass. This facade kit must be installed
prior to operation.
Replacement barrier catalog numbers are shown
here.
35” Barrier - Cat. No. F3665
40” Barrier - Cat. No. F3666
WARNING
The door should easily close without needing to be pressed down. If it has to be pressed
down to close, the gasket in the top of the door should be dressed so it lays on the glass.
Latch
Glass
Door
NOTE: When installing the glass door, ensure the spacing on both sides is even and equal.
1
2
INSPECT GASKET AND ADJUST IF NECESSARY (see pictures above)
(1) Ensure the gasket is properly positioned, and area to keep clear, is as shown.
(2) Inspect gasket after installation to ensure it appears as shown above.
Inside view
of glass door
showing
proper gasket
positioning
With door installed,
ensure gasket is po-
sitioned as shown.
Gasket
Gasket
SEE WARNING BELOW
f i r e - p a r t s . c o m
