Astria.us.com
900704-00E
16
INSTALLATION
Continued
PRESSURE TESTING HEATER GAS
CONNECTIONS
1. Open equipment shutoff valve
(see
Figure 14,
Page 15
).
2. Open main gas valve located on or near gas
meter for natural gas or open propane/LP supply
tank valve.
3. Make sure control knob of heater is in the OFF
position.
4. Check all joints from equipment shutoff valve to
gas valve
(see
Figure 15 or 16, Page 15
).
Apply
noncorrosive leak detection fl uid to all joints.
Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light heater (see
Operation
,
Page 26
depending
on your model). Check all other internal joints
for leaks.
7. Turn off heater
(see To Turn Off Gas to Appliance,
Page 26
.
Log Support Brackets
If installing an AndesMtn36, attach log support
brackets before installing logs. These brackets
are provided with the Blaze&Glow24 series burner
systems.
Figure 19- Installing Log Support Brackets
Left Log
Support
Bracket
Chassis
Right Log
Support
Bracket
Right Front of Chassis
Blaze&Glow Series Burner System
Log Compatibility Chart
Burner System
Models
Fiber Log
Models
Concrete Log
Models
Blaze&Glow18EN
Blaze&Glow18EP
AndesMtn18
BisonMtn18
RedWoodM18
Blaze&Glow24EN
Blaze&Glow24EP
AndesMtn24
AndesMtn30
AndesMtn36
BisonMtn24
BisonMtn30
RedWoodM24
RedWoodM30
Figure 18 - BG & BGE Series Burner System-
Log Compatibility Chart
Figure 17 - Control Module
POWER SUPPLY AND BATTERY INSTAL-
LATION
It is helpful to have a fl ashlight so you can see the
connections as described below. Locate the battery
power supply. It is the black box with the red and
black wires. Locate the control module
(see
Figure
17
).
Connect the battery power supply to the con-
trol module by plugging the battery power supply
to the mating receptacle on the control module.
The receptacle is located on the side of the black
control module next to the word “BATT” which is
molded in the control module’s black housing
(see
Figure 17
)
. Be certain to push the plug fully into
the receptacle. Install batteries in the battery power
supply and hand held remote control. Place the
battery box so it is located away from the burner
as much as possible towards the back left side of
the fi replace fl oor.
Connect Battery Plug Here
WARNING: Failure to position the parts
in accordance with these diagrams or failure
to use only parts specifi cally approved with
this appliance may result in property damage
or personal injury.
INSTALLING LOGS
WARNING: After installation and periodi-
cally thereafter, check to ensure that no fl ame
comes in contact with any log. With the heater
set to High, check to see if fl ame contact any
log. If so, reposition logs according to the
log installation instructions in this manual.
Flames contacting logs will create soot.
