Dear Customer,
Thank you for choosing our product to clean your pool. We hope
that you will enjoy using your new robot to maintain your swimming
pool for years to come.
Before you begin to use your robot, please take a few minutes to
carefully read these operating instructions.
Again, thank you for choosing our product.
1
IMPORTANT
CAUTION: Do not switch the pool cleaner “ON” if it is not fully
immersed in water. Operating the cleaner out of water will
cause severe damage immediately and will result in loss of
warranty.
Allow the cleaner to remain in the pool for 15 to 20 minutes
following the end of its cleaning cycle. This will allow the
motors to cool adequately. Do not leave the cleaner in the
pool all the time. Always remember to turn the power supply
“OFF” and unplug it from the power outlet before removing
the cleaner from the pool.
WARNING: Your Cleaner should not be used while people
are swimming in the pool.
Safety Note
- The unit must be supplied through a residual current device
(RCD) having a rated residual operating current not
exceeding 30 mA
- The connection to the branch circuit should be consistent
with the local and national wiring rules (electrical code).
- Mishandling of the unit can result in leakage of lubricants.
- If the supply cord is damaged, it must be replaced by the
manufacturer’s service agent or a qualified and trained
person in order to avoid hazards.
ENGLISH
Summary of Contents for Robotic Poll Cleaner
Page 1: ...BK0000911...
