Astralpool PRO ELYO INVERBOOST NN 07, User And Service Manual

Page: 39 / 317

- 35 -
Parameter checking:
Press first, then press to check the User parameter from d0 to d14
Code Condition Scope Remark
d0 IPM mould temperature
0-120
℃
Real testing value
d1 Inlet water temp. -9
℃～
99
℃
Real testing value
d2 Outlet water temp. -9
℃～
99
℃
Real testing value
d3 Ambient temp. -30
℃～
70
℃
flash if Real value<-9
d4 Frequency limitation code 0,1,2,4,8,16 Real testing value
d5 Piping temp. -30
℃～
70
℃
flash if Real value<-9
d6 Gas exhaust temperature 0
℃～
C5
℃
(125
℃
) Real testing value
d7 Step of EEV 0
～
99 N*5
d8 Compressor running frequency 0
～
99Hz Real testing value
d9 Compressor current 0
～
30A Real testing value
d10 Current fan speed 0-1200 (rpm) Real testing value
d11 Error code for last time All error code
d12 MOBUS COM 0 - 5 Setting, Modbus Only
d13 MODBUS ID Address 1 - 88 Setting, Modbus Only
d14 Product Code 0000- FFFF Setting, Modbus Only
Remark:
d4:Frequency limitation code,
0: No frequency limit;
1:Coil pipe temperature limit;
2: Overheating or overcooling frequency limit; 4:Drive Current frequency limit;
8:Drive voltage frequency limit;
16:Drive high temperature frequency limit
Press first, then press to check/adjust the User parameter from P1 to P7
Code Name Scope Default Remark
P0 Mandatory defrosting 0-1 0
0: Default normal operation
1: mandatory defrosting.
P1 Working mode 0-1 1 1:Heating mode, 0:cooling mode,
P2 Timer on/off 0-1 0
1 Timer on/off is under function
，
0 Timer on/off is out
of function (The setting of P5 and P6 won’t work)
P3 Water pump 0-1 0
1:Always running;
0:Depends on the running of compressor
P4 Current time HH:MM 00
：
00 0-23:0-59
P5 Timer on HH:MM 00
：
00 0-23:0-59
P6 Timer off HH:MM
00
：
00 0-23:0-59
P7 Water temp. calibration
-9
～
9
0 Default setting: 0
P12 MOBUS COM 0 - 5 0 Modbus Only
（
default value after reset
）
P13 MODBUS ID Address 1 - 88 9 Modbus Only
（
default value after reset
）
7. 7. 7. Start-up Start-up Start-up of of of the the the Heat Heat Heat Pump Pump Pump