Aston Martin VALKYRIE 2021, Manual

Page: 119 / 192

Maintenance and Technical Data
6.41
To install the wheel:
A second person will be required to sit in the driver seat and
apply the vehicle brakes when the centre lock nut is tightened.
1. Install a new thrust washer to the centre lock nut.
Apply grease to the mating surfaces of the thrust washer.
2. Carefully fit the wheel to the drive pegs on the wheel hub.
3. Install, but do not fully torque, the centre lock nut. Make
sure the wheel is correctly seated against the wheel hub
before the nut is tightened.
4. Lower the vehicle.
5. Using the centre lock nut socket and a suitable torque
wrench, torque the centre lock nut to 1000 Nm (740 ftlb).
6. Loosen the wheel to 0 Nm (0 lbft).
7. Torque the centre lock nut to 1000 Nm (740 ftlb) a second
time.
8. Loosen the wheel to 0 Nm (0 lbft).
9. Torque the centre lock nut to a final 1000 Nm (740 lbft).
10. Align the security cap the centre lock nut.
The centre cap tool should still be installed holding the spring
clip.
11. Fully install the security cap until it sits flush with the centre
lock nut.
12. Remove the security cap tool to engage the spring clip.
You must not drive the vehicle without the security cap
for the centre lock nut installed.
13. Install the wheel centre cap.
Tyre Repair Kit
Warning: Do not use the system to seal a tyre that was
damaged while driving with insufficient air pressure (e.g.
tyre cuts, cracks, bumps or similar damage). Do not use the
system to seal tyres with side wall damage. Only punctures in
the tread area of tyres may be sealed.
Warning: Do not stand directly beside the tyre while the
compressor is pumping. Watch the side wall of the tyre. If
there are any cracks, bumps or similar damage set the
compressor to off. The journey should not be continued.
Contact your Aston Martin Dealer.
Warning: If a tyre pressure of 1.8 bar (26 Psi) cannot be
reached then the tyre can not be sealed. Do not attempt to
re-inflate the tyre. Contact your Aston Martin Dealer.
Warning: If the pressure in the tyre after driving for 3 km
is below 1.3 bar (19 Psi) the tyre has not been effectively
sealed. The journey should not be continued. Contact your
nearest Aston Martin Dealer.
Warning: After a longer period of rest, the tyre pressure
should be rechecked.
Caution: The tyre sealant kit only provides temporary
mobility. Always refer to local laws and regulations on the use
and repair of tyres that have been treated with any form of
temporary mobility aid. Consult a tyre specialist for advice.
Inform the tyre specialist that the tyre contains sealant.
KY9Y-19A321-AA.book Page 41 Wednesday, November 3, 2021 8:41 AM